23cm transverter for 1267-1269

  • I am interested in working and receiving the telemetry from satellites on 23cm, to do that I will need a transverter.

    Can someone please give me details of where I can purchase a suitable transverter and hopefully some idea of cost.

    (Unfortunately most 23cm transverters are set up for EME, not satellites. I dont want to have to go back to a rasberry pi or similar, as I am using a Flexradio 6600 and transverters for telemetry on 2m and 70cm.)

    Thanks and best wishes the forum is a good idea.



  • Hi Achim, AO-92 is an L/V satellite ie downlink is on 1267, Fox 1 Cliff due for launch shortly will have the same L/V configuration as well of course the normal U/v..



  • Yes thanks, my mistake, but that is why I need a transverter to give me the 1267 uplink. Without the uplink I cannot turn on the downlink telemetry on 145.880 for AO-92 when it has been commanded to a 23cm uplink and not the normal 70cm uplink.

    Alternatively does anyone have any suggestion to get a suitable 23cm uplink?

    If it was EME that would be easy, as there are lots of transverters for 23cm EME.

    Also what suggestions are there for suitable antennas for the 23cm satellite uplink frequency.



  • Hi Ross

    It sounds like you have an interest in telemetry, but you also say working the satellites on 23cm. The picture to the left is ESEO (European Student Earth Orbiter). It will have an uplink on 1263.5MHz, so when you select the IF frequency on your transverter it may be worthwhile getting TX capability on 1267 and 1263. - Perhaps 70cm to 23cm as Fox and ESEO have 2m downlinks.
    Currently, it's at ESTEC in Holland, but hopefully will be on it's way to the launch site shortly. (The definition of shortly is always open to interpretation!)

    73 David G0MRF

  • Hi Thomas.

    For power budget reasons, it's important to either shut off the transmitter on ESEO when there is no one on the uplink, or change from transponder to telemetry, which uses less power. As L band is full of radar signals, we could not use 'squelch' based on signal level. The 67Hz detector is a very reliable way to trigger timers to control the transponder. Once a 67Hz tone is detected, the transponder is active. If the tone is lost, the transmitter continues for 20 seconds. In practice you may be able to have a QSO if only one person has CTCSS....but don't chat for more than 20 seconds...

  • Thanks for your comments David, sorry I have been a few days in replying.

    Can I ask why you picked 1263 as an uplink frequency. With the SG-lab transverter I can get 1266 to 1268 easily enough, but it looks like 1263 is impossible.

    Yes I do have an interest in telemetry and have been downloading data from all 3 Fox satellites and soon , of course next month when the Falcon 9 launches hopefully Fox 1 Cliff as well.

    My email address is ross.biggar@outlook .com

    I would like to hear from you.