kann jemand reflow SMD löten? Habe Teile für DB4UM PA.
pse hlp!
(looking for help in reflow soldering here in Germany)
tnx de Michael
kann jemand reflow SMD löten? Habe Teile für DB4UM PA.
pse hlp!
(looking for help in reflow soldering here in Germany)
tnx de Michael
Hi, I use air flow station https://fr.aliexpress.com/item/32878674617.html for smd chip soldering
73s
F1BPT
Has someone soldered the pcb of the amp? I used a iron from the back to heat up the pcb to about 150C and then hot air from the top. Works great for the R and C but not for the 16pin amp! Tried two times but there where short circuits
73, Mike
Use a generous (!) amount of solder flux before heating up and the short circuits should be no more.
Hallo,
Ich habe bisher meine Ceran Kochplatte verwendet geht ganz gut. Achtung nur nicht die Regierung des Hauses darf das mitbekommen sonnst kommt das Nudelholz , ich bin Single und da ist es mein Herd.
Das letzte Projekt das ich auf diese weise gelötet habe war der MCHF.
Man muß langsam die Temperatur rauf fahren und dann wenn die Oberfläche 150°C erreicht hat kurz volle Heizleistung geben. Wenn sich das Zinn verflüssigt hat langsam die Platine von der Plattenmitte in den Randbereich ziehen zum abkühlen.
73 Markus
kann jemand reflow SMD löten? Habe Teile für DB4UM PA.
pse hlp!
(looking for help in reflow soldering here in Germany)
tnx de Michael
Hi Michael,
ich habe einen Reflow Ofen und eine HotAir Station da. Die Platine und die Teile liegen auch schon bereit. Mit beidem sollte das kein Problem sein. Ich empfehle Lötpaste mit (hohem) Flussmittelanteil. Damit sollte es problemlos gehen. Ich nutze z.B. CR 44 von Reichelt: https://www.reichelt.de/loetpa…-p6833.html?&trstct=pos_0
vy73 de Florian DF2ET