Hi,
Just another user of winlink send and get email via winlink of Roberto (TNX !!!) using VARA modem.
IS0GRB Winlink Server on QO-100 (Dial 10489635.0 USB)
-
-
-
I tried as well and it seems to work very very nice!
09.10.2019 13:28:06 Connecting to IS0GRB... 1/2
09.10.2019 13:28:16 Connected to IS0GRB
09.10.2019 13:36:08 Disconnected TX: 111241 Bytes (Max: 3473 bps) RX: 127 Bytes (Max: 272 bps) Session Time: 07:52
----
** Messages sent: 1. Total bytes sent: 111113, Time: 07:46, bytes/minute: 14295
*** Messages Received: 0. Total bytes received: 0, Total session time: 07:46, bytes/minute: 0
*** Disconnecting
*** Disconnected from Winlink RMS: IS0GRB @ 2019/10/09 11:36:08
*** Session: 7.9 min; Avg Thruput: 14126 Bytes/min; 1 Min Peak Thruput: 14126 Bytes/min
-
Hi all,
I tried yesterday with my devices and this is the result:
*** Connected to Winlink RMS: IS0GRB @ 2019/10/13 07:15:42 USB Dial: 29135,000 at 2019.10.13 07:15:42
RMS Trimode 1.3.25.2
DL2BZ has 172 minutes remaining with IS0GRB
[WL2K-5.0-B2FWIHJM$]
;PQ: 69513675
CMS via IS0GRB >
;FW: DL2BZ
[RMS Express-1.5.23.0-B2FHM$]
;PR: 42960069
; IS0GRB DE DL2BZ (JN59SK)
FC EM HMHK14U8ONCM 62216 62249 0
F> B9
FS Y
*** Sending HMHK14U8ONCM.
FF
*** Completed send of message HMHK14U8ONCM
*** Sent 1 message. Bytes: 62767, Time: 03:34, bytes/minute: 17540
FQ
*** --- End of session at 2019.10.13 07:19:48 ---
*** Messages sent: 1. Total bytes sent: 62767, Time: 04:06, bytes/minute: 15280
*** Messages Received: 0. Total bytes received: 0, Total session time: 04:06, bytes/minute: 0
*** Disconnecting
*** Disconnected from Winlink RMS: IS0GRB @ 2019/10/13 07:19:53
*** Session: 4.2 min; Avg Thruput: 14951 Bytes/min; 1 Min Peak Thruput: 14951 Bytes/min
-
Hi all,
we are just taking it to the top:
*** Connected to Winlink RMS: IS0GRB @ 2019/10/19 08:05:35 USB Dial: 29135,000 at 2019.10.19 08:05:35
RMS Trimode 1.3.26.0
DL2BZ has 180 minutes remaining with IS0GRB
[WL2K-5.0-B2FWIHJM$]
;PQ: 84921629
CMS via IS0GRB >
;FW: DL2BZ
[RMS Express-1.5.23.0-B2FHM$]
;PR: 54228415
; IS0GRB DE DL2BZ (JN59LK)
FC EM 6QYYA5BGXOIR 111332 111475 0
F> 30
FS Y
*** Sending 6QYYA5BGXOIR.
FF
*** Completed send of message 6QYYA5BGXOIR
*** Sent 1 message. Bytes: 112389, Time: 06:11, bytes/minute: 18140
FQ
*** --- End of session at 2019.10.19 08:12:19 ---
*** Messages sent: 1. Total bytes sent: 112389, Time: 06:43, bytes/minute: 16700
*** Messages Received: 0. Total bytes received: 0, Total session time: 06:43, bytes/minute: 0
*** Disconnecting
*** Disconnected from Winlink RMS: IS0GRB @ 2019/10/19 08:12:25
*** Session: 6.8 min; Avg Thruput: 16476 Bytes/min; 1 Min Peak Thruput: 16476 Bytes/min
73
Bernd, DL2BZ
-
Hi,
it really works great at the moment...
DL5GAC has 173 minutes remaining with IS0GRB
[WL2K-5.0-B2FWIHJM$]
;PQ: 94210595
CMS via IS0GRB >
;FW: DL5GAC
[RMS Express-1.5.13.0-B2FHM$]
;PR: 19569603
; IS0GRB DE DL5GAC (JN47UT)
FC EM 2VA5G0O8I752 84666 84612 0
F> 12
FS Y
*** Sending 2VA5G0O8I752.
FF
*** Completed send of message 2VA5G0O8I752
*** Sent 1 message. Bytes: 85309, Time: 05:14, bytes/minute: 16270
FQ
*** --- End of session at 2019.10.19 11:19:48 ---
*** Messages sent: 1. Total bytes sent: 85309, Time: 05:46, bytes/minute: 14783
*** Messages Received: 0. Total bytes received: 0, Total session time: 05:46, bytes/minute: 0
*** Disconnecting
*** Disconnected from Winlink RMS: IS0GRB @ 2019/10/19 11:19:53
*** Session: 5.9 min; Avg Thruput: 29165 Bytes/min; 1 Min Peak Thruput: 29165 Bytes/min
73 de Robert - DL5GAC
-
Bernd and Robert:
I think people could benefit from a description of your hardware setup, power, dish, LO type, etc. used to reach this high speeds.And if you followed some procedure for setting the right audio levels and ensure clean signals.
HW?
73 de Oscar DJ0MY
-
not being on the slow side either, here's my setup:
direct digital audio from vara modem into icom ic-9700
gps-locked homebrew upconverter with commercial class A PA
about 10 watts into 120cm with poty, but not 100% clear view to satellite, partially blocked by a wall and a balcony table
-
Display More
Bernd and Robert:
I think people could benefit from a description of your hardware setup, power, dish, LO type, etc. used to reach this high speeds.And if you followed some procedure for setting the right audio levels and ensure clean signals.
HW?
73 de Oscar DJ0MY
Hello,
a bit late
, but here my setup:Uplink:
FT-857 (TCXO) - ALC max. 50% / Sound-IF Yaesu SCU-17 / TRVTR SG-Lab / GPSDO (Leo Bodnar) / PA SG-Lab (~8W for VARA) / 2.5m Airborne 10 / WIFI Grid Dish H-pol. ("barbeque antenna"...hi)Downlink:
85cm offset dish (my ASTRA-TV-dish expanded with second LNB for QO-100) / LNB from remoteqth.com
with TXCO (25.78718 mc) and really ultra low jitter (!) (LO 10.057 GHz / output 432 mc) / FT-736RAnd of course: VARA SAT high speed licence.
So, as you can see, nothing special.
73 de Robert - DL5GAC
-
Hi all,
here is a description of my setup:
+ SSB transceiver with TCXO 0,5 ppm with internal sound card or signalink sound card
+ full licence VARA SAT v3.1.2, Winlink Express 1.5.25.0
+ PC: Hardware: coffee lake, OS: Windows 7
+ DL2BZ Es'Hail2 transverter with power amp +40 dBm
+ 1m dish with winkler helix antenna for TX
+ 80cm dish with Octagon Twin PLL LNB for RX
+ cheap 75 Ohm cables widely used
73
Bernd, DL2BZ
-
Hi there.
Just tried connecting multiple times the the server at 11:10 GMT on Saturday 8th DEC and it seems that it is not listening.
I am not sure if it is just a "blip" or if it is down.
-
Hi you tried during my maintenance, now it's operational
73
LOL!!! Murphy's law!.
Sorry about that!
Thanks for the server!!
-
Hi,
I try QRP WINLINK using VARA modem. I use unlicenced version and communication is possible at very very low SNR. Practicaly it is not possible to see the signal at websdr or my receiver using waterfall.
-
Hi Roberto, I test it with the old version. I will test it again with the new one.
-
Hi Roberto, I tested also with new version with similar results !!!
It is a feature not a bug !!!
