Meinst Du den 739-144 MHz Konverter? Das ist das G0MRF Design und das sollte funktionieren... hoerst Du einen Rauschanstieg, wenn du den LNB anschliesst im Vergleich zu Konverter ohne LNB?
Transverter Store
-
-
Hmm
Rauschen tut ja nur der LNB, dieser sollte immer angeschlossen sein. Macht ja sonst auch kein Sinn.
@SWL-Oliver hat 2 RX-Rigs:
LNB --> SDR-RX und LNB --> RX-Konverter --> TS-790
Der Unterschied ist schon krass. Da ich annehme, dass Oliver seinen TS-790 kennt, vermute ich mal einen Fehler um oder im RX-Konverter.
-
Ja klar, wieviele TRX's hast Du denn noch ? Den SDR-RX hast Du wohl direkt für die 739 MHz an den LNB angeschlossen ?
-
@SWL-Oliver Ich habe den Konverter hier auch.. aber noch nicht in Benutzung. werde das die Tage mal testen und mein Ergebnis dir hier schreiben..
-
-
I have the transverters-store converter and use both the SDR port (using the converter only as LNB feed) as well as the 144 MHz converter, and it is working fine for me.
At the 144 MHz port, there are diodes as protection in case the transceiver accidentally transmits. Perhaps there has been a brief RF spike?
Also, keep in mind that the LNB produces a LARGE noise floor. Make sure your receiver doesn't get blocked; consider an attenuator to see if your receiver blocks up.
-
I`m using the same Down-Converter and it works fine for me. On 144 MHz the signal is abt 3 dB lower than on 739 MHz but that´s no problem here.
I hope you can find the problem. Otherways contact with Transverters store, I got quick answer..
73 Guntram, oe9dgv.
-
@SWL-Oliver prüfe mal das Kabel zwischen TRX und Konverter.
Ist mir noch eingefallen.
-
Oliver, bist Du am Samstag auf der UKW-Tagung? Wir koennten einen Blick darauf werfen..
-
Serge, UT5JCW hat am 5. 9. 19 seine Kunden zu diesem Problem informiert. Es handelt sich um einen Fehler bei der Herstellung des PCB. Nach Absprache mit Serge, veröffentliche ich hier seine Email zur Information:
If your converter has low output of 144 MHz signal then read below.
I discovered a problem in recent 759/144 MHz converters that causes low output of 144 MHz signal.
The PCB factory did a mistake in PCB design. Both ground wings of IC3 MAR-3 are cut off of
ground. Scrabe out blue pain along both wings (see pic1) and solder them
to the ground see (pic2). It increases 2m output at about 15dB.
Sorry for a problem.
--
With best regards Serge UT5JCW
73 de Wilfried OE9WLJ
-
-
-
I just checked mine. My must be from that lot of PCBs, did this GND contacts and see the large improvement.
I checked mine and that PCB was OK, no GND jumper req'd. So there are different batches of PCB's.
-
@SWL-Oliver Freue mich dann auf dein Ergebnis..
-
ja genau so ist es..
-
I checked mine, GND-connection is ok, no need to change anything.
-
-
I got mine on August 7th.
-
-