How can i change the power output of my Pluto with the F5OEO update/change software in DVB mode?
With the DATV-Express software there was a sliderbar for tx power.
73,
Bert
Adalm-Pluto
-
If you are referring to the new firmware that uses RTMP stream, the power is a parameter on the stream command. If you are using the UDP method, there is a web interface to set power and frequency. Just login to the Pluto web server (just type it's IP address into a web browser) and follow the link.
Mike
-
Hello everyone here the ON7ATV damn get my pluto friday here so think this evening go to update it all fine whats happend the led is flash good and quick so all good then my desktop go out and now a pluto just led1 on and see nothing on the device more ??? how helps me for set it back if possible normal i use a lime but will test on the 2 systems thanks a lot the Alain
-
ON7ATV Alain goto this link..starting on page 26 the boot process is described. https://www.gnuradio.org/grcon…r/8-Michael_Hennerich.pdf
-
ok Good morning Heiner i prg a notebook to linux and try the procedure that i see hope its back to life 73's and thanks for info !!!!
-
-
PROBLEM SOLVED try at last on cmd in windows and with bat file reflashd it to 0.31 and works again everyone thanks for help !!!!!
-
I try to setup a USB2.0 Ethernet AX88772 adapter but it does work. I try the adapter to my PC and it works (it is really a AX88772 ). I also use a tested OTG adapter. Power is feeding the Ethernet adapter. The problem is that it does not light the ethernet link led at my switch. I put this config :
[USB_ETHERNET]
ipaddr_eth = 192.168.1.99
netmask_eth = 255.255.255.0
Any ideas - proposals ?
-
I had to use an OTG power cable with a separate DC feed. The current required was too much for the pluto.
-
I use this ETH/USB-OTG adapter: https://www.amazon.com/gp/product/B00RM3KXAU (with two ferrite clips over the short cable) and a separate 5V power supply. Without ferrite clips i have had similar problems (sometimes no ethernet connection).
