Hi, trying to implement "poor man H.265 encoding solution" using these H.265 Encoder Box available from AliExpress.
Using Pluto with latest alpha 2908 firmware version from F5OEO, even following the good guide by F5UII the images are going out OK but still struggling to get the audio out. Some points intrigues me:
1.As soon as Pluto boots up it overrides the previous configuration saved in the H.265 encoder box to this shown in picture A, so I need manually to change the config back as shown in picture B. Is there any way to avoid it?
2. Also when Pluto boots up it already starts with PTT ON, is it possible to change this condition on start?
3. Using the UDP option as described in F5OEO documentation page (picture C) it would be an option to the HDMI connection or it is necessary to be configured anyways? My H.265 box here would not accept Sub-Stream set, only main-stream when Pluto is connected (picture D) or we must change something in the H.264/H.265 Control menu? (Figure E)
Thanks and sorry for excess of pictures, next time better I make a movie!