LAN operation on Pluto needs crazy amounts of network bandwidth. Is there a way to limit that ?

Dear All ,

I have my station setup as a networked adalm pluto.
When I used it on my local network my SDR console clocked at 100MBits network traffic almost saturating the Pluto network interface.
Even going at 550khz radio bandwidth the network bandwidth needed was around 20mbits ..

So my question is is there any other way to operate the pluto that is a more network lenient mode ?
aka.: Does not consume this crazy amounts of network bandwidth for simple operation ( SSB voice) .

please see attached.
[Blocked Image: https://scontent.fath4-2.fna.fbcdn.net/v/t1.15752-9/273941394_2670241969789329_1175599141494660048_n.png?_nc_cat=108&ccb=1-5&_nc_sid=ae9488&_nc_eui2=AeHNTrlrzfTWyG-gFNJu31Vz8dUXTj4QUe7x1RdOPhBR7kDRTO3A2a4s9-LuLMoiIH0&_nc_ohc=6pqyAdGcZi8AX8yb_yM&_nc_ht=scontent.fath4-2.fna&oh=03_AVJyLC5PsgyHRSxMqLCOa3NP80remgqXiywlvtJ9z8eRPA&oe=6249BD14]

Thank you in advance

5B4AKV

Dear Mr.DM5RM Roland ,



Yes I do know this is accurate because I got such values under testing conditions, and of course calculating them as you just did ,



The issue is how can I just transport audio or some other method that does not need so much bandwidth ,

like for example KiwiSDR web console ( based on open web rx) or openweb rx or SDRplay TCP method ? .. ?



any ideas ? ( how to do it / implement it ? )



Thanks in advance



5B4AKV

Quote from DM5RM

Hi Alexandros,

the range of values is correct.

550kHz bandwidth requires at least 550kHz sampling rate for the Pluto. With 16 bits each for the I and the Q signal, this results in 17.6Mbit/s without any overhead.

In full-duplex operation, this is twice as much...

73 Roland

Display More