Posts by DL8SDQ
-
-
Hello,
I am watching the Beacon since this mornig. It is working fine.
My setting with VB Cable you need to set under RX the Cable output and in
SDR Console the Cable input.
It take a while to open the Webpage you need to wait till the webpage was transmitted.
Could take a couple of minutes.
You can see under "File" what's received in the moment.
Here the setting in SDR Console with the Cable input.
I had some problems to make a screen copy in full width.
73, Juergen, DL8SDQ
-
Hello Pavel,
I am using 2 Mini Tiouners Ver. 1.1 and 2 with Scan and tioune since 2 years now. It works great.
If you need more info let me know.
73, Jürgen DL8SDQ
-
Hello Frank,
you are the first to report that the link was broken.
Here the 2 Files again.
German:
https://magentacloud.de/s/MJe7H4L5wmBmrDn
English:
-
Hallo Thomas,
kannst du gerne tun wenn's hilft.
73, Jürgen DL8SDQ
-
I transleted my German document to English I hope it is not too bad in wording.
This is a link to the German document.
https://www.magentacloud.de/lnk/XS4MpQD6
This is a link to the English document.
https://www.magentacloud.de/lnk/w9YsJkRC
-
Hello,
I try to use my TS2000 with the SDR Console V3.0.26.
The TS2000 is in satellit mode TX 144 MHz, RX 1242 MHz.
I setup an external radio setup.
As you can see the radio is online and it ist working. I can change the frequency in the SDR console and the freqiency in the TS2000 follows.
I made the setting as following:
So I would assume that the data goes from the SDR console to the TS2000, but if I trun the VFO at the TS2000 the data is transmitted from the TS2000 back to the SDR console.
But the TX frequency is transmitted back. This causes the SDR console to jump the 144 MHZ mit TX frequency on the TS2000.
To return to 1242 MHZ I need to pess the PTT.
Does somebody have an idea what to do to prevent the data from going back to the SDR console. I thought by disabling the check boxes Rado -> SDR this would do the job.
73, Juergen, DL8SDQ
-
Hello I did some modifications and some measurements on this Siemens Nokia PA block.
As I got the tip from Manfred DK5FA I got 2 units.
This is a link to the German document.
https://www.magentacloud.de/lnk/XS4MpQD6
This is a link to the English document.
https://www.magentacloud.de/lnk/w9YsJkRC
if you follow the link you can load my modifications so far.
The document is only in German. I include also the schematics for the bias current regulation for the final LDMOS and the driver MOS. I hope this is helpful for you.
Has anyone a info about the directional coupler and the output at X102
73, Jürgen DL8SDQ
