Posts by DK7NC

    Hallo Matthias,


    Vielen Dank für deine Antworten.


    Ich meinte natürlich den AMSAT-DL Downconverter V3d mit dem GPSDO V1 den habe.


    Suche weiterhin nach der besten Lösung um den fixen bauartbedingten Frequenzversatz der Version 1 zu korrigieren. Die OLED zeigt neben den von dir genannten GPS-Werten auch die ausgewählte LNB-Frequenz und die selektierte Ausgabefrequenz an. Diese Information würde man dann leider auch verlieren.


    Debatiere weiterhin mit mir selbst ...


    Gruß

    Frank

    A piece of copper would most likely shorten some of the component connectors on the underside of the circuit board. That was the main reason to use a thermal pad in the first place. This is what the documentation says, if I remember correctly.

    My UpCon6W aluminium block was getting quite hot after a few minutes into a QSO when I tried it for the first time this week. I think it went up to around 60 degrees.