Whats about Leila to such a strong signal?
Posts by DJ7WL
-
-
But mouse operation will still be possible? I use only a "normal" Monitor.
-
Today i set up my test environment for a first try of my raspberry pi.
Download the image file and programmed the content to a micro sd card.
Plug the micro sd card into the raspberry slot.
Connected the HDMI output via a VGA converter to a older 4x3 monitor.
Connected a mouse to one USB port. Connected a SDR stick to another USB port.
Connected a short whip antenna to the SDR stick. Ready is the test environment.
Switch monitor and power supply for the raspberry on.
After a short time the raspberry has booted. With the mouse I open the following picture.
Start SDR Receiver and SAT Controller, following picture opens.
All is working from the beginning. Next step will be to connect a further SDR stick and the sat signal.
-
Quote
DJ7WL : Due to my informations, new Octagon OTSLO will on the marked end of this months.
My Satshop call me with the message the Octagon OTSLO Twin with PLL will be available not before end of april.
But he send me a link with a new Octagon PLL type as well as a 25MHz xtal.
-
Due to my informations, new Octagon OTSLO will on the marked end of this months.
-
DD4YR
Hallo Robert, wie hast du das GPSDO Signal in den GM 201 eingespeist, via Kabel oder direkt?
-
Ok, thank you, this is a smart solution. I will read it carefully.
With the third generation off satellites system on board of vessels we had a similar system. Only one single coaxcable between the antenna system and the below deck unit. Via this cable was running the power for the antenna, reference frequency, IF frequency, transmit frequency and a serial communications line. The processor inside the antenna radom pointed the parabolic dish always accurate to the geostationary Inmarsat satellite no matter what the ship below the dish is doing.
-
Hi Michael,
on what way you feed the referencing cable into the box to make it waterproof?
-
I had also no problem with download and unzip.
WinRar-ZIP download 2.147.629 KB
If the download is finished you will see 2.0/2.0 GB below the filename.
You must wait until this information below the file is gone.
I just tested it a second time and it works perfect.
For unzipping i use a quite new l Winrar
-
Hi Frank, download and unzip ok. Will install it soon on my raspberry pi. First test for me will be the lock to master funktion. Let you know soon my results.
-
I have only 4 meter between the dish and the transverter in my radioroom, so that will not be a big problem, as i hope.
-
Hi Heiner
thank you for the fast response. Well, i will ask there what time the transverter is on stock again. Will be the banktransfer with IBAN and BIC possible? Due to your message a PA will not be neccessary?
-
Hallo Berndt,
Hat schon mal jemand Transverter von SG Lab bezogen und kann etwas über die Qualität aussagen? Auf den Bildern sieht es ja solide aus.
-
Congratulation also from me. Really well done.
-
Good job, thank you
-
Will the opening ceremony be broadcast on TV or Internet?
-
Also i like to participate in this project. Will order 2 SDR sticks as well as a raspberry pi just now. Hopefully everythings will work fine after the opening party at the groundstation of Amsat-DL.