Posts by DD0KP
-
-
I use RF-240 which has 0,42db/m @ 2400 MHz it is a little better than H-155 which has 0,49db/m @ 2400 MHz
-
BG0AUB I did the following:
LNB to horizontal 12V feeded with a bias-T so there is no voltage going to SDR or minitiouner. In front of the bias-T is a simple sat splitter..One output to minitiouner the other to sdr rx. Then look with this setup (12V) to the best s/n for the NB.. this will also be the best s/n for the WB..I do not switch to Vertical, because the noise is more on NB and so I can avoid an attenuator for the sdr..
-
-
-
-
Other suppliers sell the same design as 4 Watt versions!!!
-
PA3FYM You must check in the designs the datasheet values for Bias and supply power.. if you look to the datasheet you find the needed informations:
-
I am running here TT-1600 as well..
-
DC8GY Did you use the Tioune software from F6DZP with the special drivers? or which program you use?
-
David G0MRF here is a 4watt version you can buy this complete or PCBA only:
-
PA3FYM Do you have a schedule for the mirochip samples??
-
DL5RDI Johannes I checked the twitter link..tnx.. the question of measuring the power is what is the input signal ssb or datv
-
I put the datasheet here direct.. there are clear information regarding the bias voltage, supply voltage..
-
It will be interesting to know which components are in the square 8w version..
-
I8LYL former I0LYL this is for the 4W version.. I know the datasheet typical design looks live this:
-
-
Warm welcome here Martin..
-
Darko do the shipments from Austria for Europe...
-
DL1YAK Darko is OE7DBH and here the link: