Maybe your type 167 is a good fit for putting into a 25MHz PLL LNB??
Posts by DD0KP
-
-
ok.. i think the best fit is the PL902Q42 link here:
http://clockworks.micrel.com/T…sheetsPDF/PL902Q42USY.pdf
Other devices handle 10MHz with different output levels:
PL902... 162, 169, 171, 177, 178
So next is to find the spec how to order a new type.. when I found this..we can make a perfect GPSDO type
-
I just check the 55 sheets.. I will response after that..
-
http://clockworks.micrel.com/T…sheetsPDF/PL902167USY.pdf
you have a 25MHz device!!
-
got it... http://clockworks.micrel.com/T…gn/listing/search/DKpl902
there are 55 versions availabe.. e.g. PL902Q42USY has the following data:
http://clockworks.micrel.com/T…sheetsPDF/PL902Q42USY.pdf
5MHhz and 10Mhz
-
On this Microchip page you find many different types..
-
PA3FYM I just try to figure out what the three "x" mean. They write factory configuration but I do not find the programming spec at the moment. what is on your chip K2xxx.. can you tell me this pse..
-
pe1chl I also prefer this solution and it is very easy to do..
-
PA3FYM you can store your setup with the Ublox Software into the EEprom.
-
boungiorno Alfredo..benvenuto qui
-
-
-
-
good job Michael..
-
i am running 60cm dish and it works also with datv
-
-
-
-
-
Here the link from John G4BAO on youtube from todays transmission..
External Content www.youtube.comContent embedded from external sources will not be displayed without your consent.Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.