Here is the measurement of the filter I have. It looks simmilar to the picture from the advertisement. For WB some adjustments are needed:
Will you work out how to move frequency upwards for WB?
Here is the measurement of the filter I have. It looks simmilar to the picture from the advertisement. For WB some adjustments are needed:
Will you work out how to move frequency upwards for WB?
And if the sample fulfills our requirements than does did not mean that the mass production has the same quality ....unfortunately my experience.
You have to be onsite to verify/control the production process
Looks like the dish sold by G3RUH:
More about it here:
One of several links:
stopped at 13:58 UTC
continued at 14:10 UTC
Hi,
currently, 11.02.2019 @ 13:20 UTC, on the wideband transponder the promo video of Es'hail is shown, H.264 DVB-S2. Low MER....hard to decode
10495000 6500ks 5/6 QPSK
uplink from Qatar / A71A
How big would be the effort to move the center frequency of the passband a little bit to higher frequencies?
I do not have access to an analyser..
Out of curiosity:
Would this module be used in A-mode or AB-mode for best linearity?
Hi,
for the DATV transmission a DVB-S and DVB-S2 receiver is necessary. As also DATV transmissions with reduced bandwith are to be expected, a good solution could be using Mini Tioune. Have a look here:
https://wiki.batc.org.uk/MiniTioune
I guess that worldwide analog transmissions via Sat are not longer available.
If you wish to use a commercial receiver make sure that it allows symbol rates lower than 1 Mbit.
The RED (radio equipment directive) applies.....CE is only one part of the story.
But customs officers are mostly not so deeply involved in european laws.
Hallo Achim,
was muss man beachten, wenn man den 2.4GHz 20W Booster bestellt?
Welche Zollrechtlichen Dinge sind zu beachten?
Muss aus der Rechnung ersichtlich sein, dass es sich um Amateurfunk Ausrüstunghandelt?
73 Hans-Jochen DK1MG
Moin,
meistens schreiben die chinesischen Versender nur unspezifische Angaben auf den Versandkarton. Je nach Versandweg kann das Päckchen problemlos durch den Zoll gehen oder Du bekommst einen Brief vom Zollamt, dass Du dort die Sendung abholen und verzollen bzw. die Einfuhrumsatzsteuer zu entrichten musst. Die Sendung wird in deinen Beisein zollamtlich geöffnet und begutachtet. An dieser Stelle ist die Vorlage der Amateurfunkgenehmigung und eine einfache technische Erklärung, was mit diesem elektronischen Bauteil passieren soll, hilfreich. Die Beamten beim Zoll sind keine Techniker, aber häufig technisch interessiert. Die meisten Beamten schauen nur nach dem CE-Kennzeichen und einer deutschsprachigen Anleitung (beides Pflicht bei "normalen" Wirtschaftsgütern). Hier hilft der Hinweis auf die Rechte und Pflichten des Funkamateurs bzgl. Selbstbau.
Hoffe, ein wenig geholfen zu haben.
vy 73 de Rainer, DG8KD
For stationary work I will use two antena system. For rx 100cm dish with Kuhne MKU LNC and 80cm with homebrew 5 turn helix for txing.
Why are you using the smaller dish for transmitting???
Hi,
I also wrote an email to them a few days ago asking for LHCP and a slight shift of the frequency. Let´s wait for the answer.
Here the direct link to the antenna (last one on the page):