Posts by DD0KP
-
-
dj0abr Kurt I did tests indoor with DVB-S and DVB-S2 with 2Msample to receive it with my V8 Satfinder.
That works very stample here.. 333Ksample I did not
try yet.
-
RK3DJW Andrey..best solution is going with the 20W PA from LZ5HP.. you can order it on the internet by Paypal. I have the PA running here over month and I am very satisfied.
-
G4NRT David may be the manual will help you...
-
DK4FT can you send me a picture of your PA Alex?? Then I can check if I have the same her..Thanks..
-
vu3jnm 12Volt is ok. You should use a bias-t to supply the lnb. there should be no voltage to the rtl-dongle input. You could test the rtl-dongle by a normal radio station if this works you should turn your lnb for best scew angle.
-
VU3BCN perfect...congradulations..
-
VU3BCN if I put my lnb into the dish original 90deg. I get the beacon with a mer of only 3.. if I turn it to the skew angle which fits best I just get a mer of more than 7 with just turning the lnb the right way..
-
VU3BCN ok.. I think this you also will fix pretty soon. If everything works with version v0.8.. then you after that can also use v0.9 very easy.
USB3.0 is highly recommended for gettting a good I2C rate from the minitioner express to your computer.
-
VU3BCN Priyasloka I just send the whole sw packege to VU3OBR.. I think he will forward you what you need..
-
G0MJW Mike take a look to PA3CSG page.. there you find what you need for low prices. He will send it usually out the next days.
Hope this helps you..
-
VU3BCN try it please with your minitioner express.. this should work.. use the minitioner v0.9 software from Jean Pierre. If you do not have it.. drop me an email at call@darc.de then I can send it to you.. and if needed we can also start teamviewer and then we can solve it together..
-
OH1NHW No Ismo.. you can cut it to the lengh you want.
-
PA3FYM no Remco.. that does not happen.. you can get it from Mouser as well..
If you want.. two on stock..
-
DF6LO This is an endcap for a 11cm plumb pipe.. You must drill a 22mm hole in the middle to let the 10 GHz through. then shorten the endcap to 1,5cm so that it fits best into your dish. the lens is sealed by superglue and silicone. That you could also do on the backside.. but when you running an offset dish.. that is no issue.. because the rain will never reach that.
-
HB9SKA and the OM behind this is Hanspeter DK1YQ in Ismaning near Munich..
-
That is not my budget...
-
-
-