Dish Clearance, metal roof

  • Hello all. I am just about to order a roof mount (tagelvoet) that uses 60 x 40 x 5mm concrete tiles for ballast. The ballast weight is approximately 108kg


    My intention is to mount the dish and mount on top of a flat metal shipping container that I use for storage. It is clear in the direction of the satellite. I have a Triax TDS 110 offset fed dish. The standard pole for this roof mount is 70cm long which means that the lower edge of the dish will be around 25 cm above the metal roof and around 1.5m from a wall to the West of the dish.


    How much clearance do I need?


    I can buy a 120cm pole but then I should probably go to a 60mm diameter pole instead of the supplied 48mm.


    I have no idea what is needed, I don't want to pick up noise from the container.


    Thanks in advance.


    Conrad PA5Y

  • Hoi Conrad,

    Even snel in het Nederlands...


    Je hebt iets meer ruimte nodig voor satellite kabel omdat de LNC waarschijnlijk wat achter de poty hangt en dus wat lager.

    De hele zaak kijkt schuim omhoog dus daar heb je geen last van...

    Belangrijk is wel te begrijpen wat voor een dualband antenne je gaat gebruiken..

    poty heeft een 22 mm buis straler voor 10Ghz waarachterop de lnc wordt geplaatst.

    een helix heeft vaak een groot gat waarin de lnb wordt gedrukt.


    Helix heeft 3db gain voor TX ten opzichte van een POTY maar je verliest ong 3dB in je RX door shielding van het ontvangst door de helix straler...


    Ik heb voor portabel gebruik mijn 1,2 meter offset op zijn kop gezet.

    Het voordeel is een veel stabielere opstelling met minder windvang en de feed is makkelijker aftedekken met een broodzakje...

    Maar dan zal je de montage buis onder ong 30 graden schuin moeten hebben... (mijn 3 poot is dus zonder midden buis en de offset monteer ik op zijn kop aan 1 van de 3 poten.


    keuzes genoeg...

    Wat zijn je plannen?


    73es Benno PA3FBX.